Samsung UE32EH5000 LED LCD TV Review

Vincent Teoh

For the second year running, it’s only around this time in December – when most of the TVs have been covered and the gongs awarded – that we get around to reviewing an entry-level offering from Samsung Electronics, the world’s largest television manufacturer. For 2012, this comes in the form of the UE32EH5000, a 32-inch direct LED-lit LCD TV with full HD 1920×1080 screen resolution.

Compared to last year’s equivalent model (the UE32D5000), the 32″ EH5000 has gained Freeview HD support via an integrated DVB-T2 tuner, but lost two HDMI ports (down from 4 to 2). Priced at below £300 online at this time of writing, the display won’t break the bank too, but is it value for money, or just false economy? We’re about to find out…

Note: The sample we tested was the Samsung UE32EH5000KXXU (the 3-pin-plug United Kingdom model), version number 01. According to the service menu, it uses a Chi Mei LCD panel.


Upon unpacking the TV for assembly, we experienced a throwback to the days before super-slim LED televisions became all the rage – the Samsung UE32EH5000 sports one of the bulkiest backside we’ve seen on a flat-panel HDTV in a long while. Were it not for the “LED TV” label on the box, the 32EH5000 could very well pass for a more traditional CCFL-backlit LCD television.

Samsung UE32EH5000

But since we do not watch TV from the sides, we were totally unfazed by the set’s chunkier form factor. From the front, the LCD screen is coated with a sheen that is halfway between matte and reflective, which shouldn’t pose a problem even in the brightest of rooms. This is in turn framed by a thin bezel finished in glossy black, matching the coating on the pedestal stand’s oval base.

Remote control

The supplied remote control is small and functional. The rubbery buttons do not give particularly good tactile feedback, nor are they backlit. The overall quality and feel is in keeping with the UE32EH5000’s budget proposition.


Rear connections on UE32EH5000
2 x HDMI, USB, CI slot, Component, SCART, aerial, ethernet & audio outs



Hoping to obtain a greyscale that’s closest to D65 industry standard out of the box, we popped the Samsung EH5000 into [Movie] mode, with [Colour Tone] left at its default setting of “Warm2“. Here’s what we got:

Pre-calibration RGB Tracking
Pre-calibration RGB tracking and delta errors (dEs)

For the most part blue channel was underfilled, causing what should be neutral shades of grey to take on a red tint. Fortunately the LED LCD TV comes with 2-point white balance controls in its user menu, allowing us to address the issue.

Post-calibration RGB Tracking in [Movie] mode
Post-calibration RGB tracking and dEs in [Movie] mode

After some brief adjustments, the on-screen picture looked much healthier. Delta errors (dEs) were reduced to below 2 from 30% stimulus onwards, which is very good going for a sub-£300 television.


Prior to calibration, overall gamma in [Movie] mode was measured to be higher than the 2.4 reference we now aim for. Low-end gamma even exceeded 2.5 at certain points, which would cause shadow detail to be obscured.

Pre-calibration gamma trackingPost-calibration gamma tracking
Post-calibration gamma in [Movie] modeCorresponding gamma tracking

The UE32EH5000 features a single [Gamma] control that lets you raise or lower the gamma across the entire luminance range. We changed its value to “1” to bring gamma in line with our 2.4 target. Due to the absence of 10-point gamma or white balance controls, we could not flatten the slight bump at 10% stimulus (read: shadow detail will look darker than it should be) nor the dip at 90% stimulus (i.e. bright highlight will look brighter than it should be), but these are minor shortcomings in the grand scheme of things considering the price of the display.


The Samsung 32EH5000 offers two [Colour Space] presets: “Auto” and “Native“. Of the two, the former is more accurate – the latter yielded a pale, bluish green that looked sickly.

[Colour Space] Auto[Colour Space] Native
[Colour Space] “Auto”[Colour Space] “Native”

Given the omission of a colour management system (which is presumably reserved for more expensive, step-up models), the only controls we had available at our disposal to affect proceedings were the [Colour] and [Tint] sliders. Following greyscale calibration, the secondary colour hues fell into place quite nicely, so we left [Tint] unchanged at its default value of “G50/R50“, and only had to contend with [Colour].

The quandary is that [Colour] affects both colour saturation and luminance at the same time, therefore settling on a value became a fine balancing act. Normally we prioritise getting colour luminance (also known as colour decoding/ brightness/ intensity) right, particularly for red primary since red push can stick out like a sore thumb to discerning viewers.

However, on the Samsung UE32EH5000 we found that colours tended to run “hot” (that is, they appeared more saturated than they should be) at sub-100% saturation intervals, so we decided to dial [Colour] down a notch, which as it turned out did not negatively impact colour decoding in a significant manner.

Colour saturation tracking
Post-calibration CIE chart with saturation tracking
Post-calibration Luminance levels in [Movie] mode
Post-calibration colour luminance (coloured bars = targets; black bars = measured values)

Benchmark Test Results

Dead pixelsNone
Screen uniformityVery good for an LCD TV panel
Overscanning on HDMI0% with “Screen Fit” selected
Blacker than blackPassed
Calibrated black level (black screen)0 cd/m2 (LEDs shut off)
Calibrated black level (ANSI checkerboard)0.035 cd/m2
Black level retentionAuto-dimming with full black screen
Primary chromaticityDecent
ScalingExcellent, smooth
Video mode deinterlacingVery effective jaggies reduction
Film mode deinterlacingPassed 3:2 and 2:2 cadences with [Film Mode] engaged
Viewing angleDecent for an LCD TV
Motion resolution300
Digital noise reductionOptional
SharpnessDefeatable edge enhancement
1080p/24 capabilityVery mild judder – negligible at this screen size
Input lag20ms compared to lag-free CRT
Full 4:4:4 reproduction (PC)Yes, with input label set to [PC]

Power Consumption

Default [Standard] mode44 watts
Calibrated [Movie] mode33 watts
Standby<1 watt

Note: Measurements taken with full-field 50% grey screen.

Jump To: 1. Design & CalibrationNext: Performance
  1. Samsung UE32EH5000 Design & Calibration (Current Page)
  2. Samsung UE32EH5000 Performance

jQuery(document).ready(function($) { var toc = $("#tableofcontents").html(); $("#tablecontents").html(toc); });